Pilot 2WD V6-3.5L (2006)
Door Lock Cylinder Switch: Testing and Inspection
Door Key Cylinder Switch Test
1. Remove the door panel.
2. Disconnect the 3P connector from the key cylinder switch.
3. Check for continuity between the terminals.
-
There should be continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in the LOCK position (Except driver's
without security).
-
There should be no continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in the neutral position (Except
driver's without security).
-
There should be continuity between the No.1 and No. 2 terminals when the door key cylinder switch is in the UNLOCK position.
-
There should be no continuity between the No. 1 and No. 2 terminals when the door key cylinder switch is in the neutral position.
4. If the continuity is not as specified, replace the switch.
NOTE: Make sure the slot in the switch is properly aligned with the tab on the key cylinder.