Pilot 2WD V6-3.5L (2006)
Check for continuity between the terminals.
-
There should be continuity between the No. 1 and No. 2 terminals when power and ground are connected to the No. 3 and No. 4 terminals.
-
There should be no continuity between the No. 1 and No. 2 terminals when power is disconnected.
Front Accessory Power Socket
Front Accessory Power Socket Test/Replacement
1. Remove the center lower cover.
2. Disconnect the 2P connector from the front accessory power socket.
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the socket.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the No. 2 terminal and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 5.
-
If there is no battery voltage, check for:
- Blown No. 8 (7.5 A) fuse in the driver's under- dash fuse/relay box.
- Blown No. 9 (15 A) fuse in the passenger's under-dash fuse/relay box.
- Faulty accessory power socket relay.
- Poor ground (G503, G651).
- An open in the wire.
5. Check for continuity between the No. 1 terminal and body ground. There should be continuity.
-
If there is continuity, go to step 6.
