Pilot 2WD V6-3.5L (2006)
7. Remove the brake disc retaining screws (A).
8. Screw two 8 x 1.25 mm bolts (B) into the brake disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc
excessively.
9. Remove the brake disc from the hub.
10. Check the front hub for damage and cracks.
11. Remove the cotter pin (A) from the tie-rod end ball joint, then loosen the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
12. Disconnect the knuckle using the special tool.
13. Remove the lock pin (A) from the lower arm ball joint castle nut (B), and remove the nut.
NOTE: During installation, install the new lock pin after tightening the new castle nut.
14. Disconnect the lower arm ball joint from the knuckle using the special tool.
NOTE: Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
