Pilot 2WD V6-3.5L (2006)
18. Install the new pump seal (A) (with its grooved side facing in) into the pump housing (B) by hand first, then drive it in using the special tools with
until there is no step at the top of the pump seal, and the seal is fully seated in the pump housing.
19. Position the pump driveshaft (A) in the pump housing, then press it in with the appropriate size socket wrench (B) as shown.
20. Install the 40 mm snap ring (C) with its beveled edge facing out.
21. Coat the new pump cover seal (A) with power steering fluid, and install it into the groove in the pump cover (B).
22. Install the outer side plate (C) over the two roll pins (D).
