Pilot 2WD V6-3.5L (2006)
23. Set the pump cam ring (A) over the two roll pins with its "^" mark (B) facing down.
24. Assemble pump rotor (A) to the pump cover (B).
25. Set the 10 vanes (C) in the grooves in the rotor. Make sure that the round ends (D) of the vanes are in contact with the sliding surface of the cam
ring.
26. Coat the new 15.2 mm O-ring (A) with power steering fluid, and install it into the groove in the side plate (B).
27. Install the side plate on the cam ring (C) by aligning the roll pin set holes (D) in the side plate with the roll pins (E).
28. Coat the new 51 mm O-ring (A) with power steering fluid, and position it in the bottom of the pump housing.
29. Install the pump cover assembly (B) in the pump housing. Tighten the bolts to the specified torque alternating in two or more steps.
