Pilot 2WD V6-3.5L (2006)
Steering Wheel: Service and Repair
Steering Wheel Installation
Steering Wheel Installation
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about two and half turns. The arrow mark (B) on the cable reel label point
should point straight up.
2. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown. Install the steering wheel on to the steering column shaft, making sure
the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel or
steering column shaft when installing the steering wheel.
3. Install the steering wheel nut (A) and tighten it to the specified torque. Connect the horn switch, radio remote switch, and the cruise control
set/resume switch connectors. Make sure the wire harness is routed and fastened properly.
4. Install the driver's airbag, and confirm that the system is operating properly.
5. Enter the anti-theft codes for the radio and the navigation system, and reset the clock.
6. Check the cruise control, radio remote, navigation system, and turn signal canceling for proper operation.
