Pilot 2WD V6-3.5L (2006)
15. Remove the damper pinch bolts (A) and flange nuts (B) from the damper.
NOTE: During installation, install the new damper pinch bolts and new flange nuts.
16. Remove the driveshaft outboard joint (C) from the knuckle (D) by tapping the driveshaft end (E) with a plastic hammer, then remove the knuckle.
NOTE: Do not pull the driveshaft end outward. The inner driveshaft joint may come apart.
17. Separate the hub (A) from the knuckle (B) using the special tool and a hydraulic press. Hold the knuckle with the attachment (C) of the hydraulic
press or equivalent tool. Be careful not to deform the splash guard. Hold onto the hub to keep it from falling when pressed clear.
18. Remove the snap ring (A) and the splash guard (B) from the knuckle (C).
