Pilot 2WD V6-3.5L (2006)
16. Remove the flange bolts (A), and separate the knuckle from the trailing arm (B).
NOTE: During installation, install the new flange bolts.
17. Place a floor jack under lower arm B. Remove the self-locking nut (A), washer, and flange bolt (C).
18. For 4WD models: Remove the knuckle while pushing in the driveshaft and holding the driveshaft outboard joint.
NOTE: Do not pull the driveshaft end outward. The inner driveshaft joint may come apart.
19. Separate the hub (A) from the knuckle (B) using the special tool and a hydraulic press. Hold the knuckle with the attachment (C) of the hydraulic
press or equivalent tool. Be careful not to deform the splash guard. Hold onto the hub to keep it from failing when pressed clear.
20. Remove the flange nuts (A), backing plate (B), and snap ring (C).
