Pilot 2WD V6-3.5L (2006)
8. Use a power drill with an 11 mm drill bit to drill out the hole in the valve stem ball just enough so you can remove the valve stem from the wheel. Be
careful not to damage the wheel as you're doing this step. When you're done, go to Installing the Replacement Valve Stem Assembly.
9. Remove the valve stem and the screw from the tire pressure sensor. Discard the valve stem and the screw, but keep the sensor. Also, make sure the
valve stem grommet is removed; sometimes it gets stuck in the wheel.
Installing the Replacement Valve Stem Assembly
1. Insert the new screw into the tire pressure sensor, then screw on the new valve stem, finger-tight.
2. Clean the mating surfaces on the tire pressure sensor and the wheel.
