Pilot 2WD V6-3.5L (2006)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve A and Replacement
A/T Clutch Pressure Control Solenoid Valve A and Replacement
1. Get the customer's radio (and navigation) anti-theft codes, and write down the audio presets.
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery and battery tray.
4. Remove the intake manifold cover and air intake duct.
5. Remove the battery base and battery base bracket.
6. Remove the nuts securing the shift cable bracket (A).
7. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
8. Remove the bolt securing the harness cover (A).
9. Remove the harness clamp (B) from the harness cover/clamp bracket (C), disconnect the 4th clutch transmission fluid pressure switch connector
(D), then remove the harness cover from the bracket.
10. Disconnect the A/T clutch pressure control solenoid valve A connector (E), A/T clutch pressure control solenoid valve B connector (F), solenoid
harness connector, transmission range switch connector, ATF temperature sensor connector, output shaft (countershaft) speed sensor connector,
input shaft (mainshaft) speed sensor connector, and 3rd clutch transmission fluid pressure switch connector.
