Pilot 2WD V6-3.5L (2006)
7. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 inch) If the height is over 7 mm (0.3 inch), push the pipe until it bottoms in the accumulator body.
8. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end in the transmission
housing and 8 x 25.2 mm ATF pipe (D).
9. Install new O-rings (E) over the ATF joint pipes.
10. Install the A/T clutch pressure control solenoid valve C.
11. Install the intake air duct and intake manifold cover.
