Pilot 2WD V6-3.5L (2006)
11. Remove the A/T clutch pressure control solenoid valve A and B, ATF pipes (C), gasket (D), and O-rings. (E). Note the lengths and locations of
the ATF pipes.
12. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
13. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
14. Install the A/T clutch pressure control solenoid valve A and B.
15. Install the harness cover on the cover bracket, and secure it with the bolt.
16. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely. Install the harness clamp on the
bracket.
17. Attach the shift cable end to the control lever, then insert the control pin into the control lever hole through the shift cable end, and secure the
control pin with the spring clip/washer.
18. Secure the shift cable bracket with the nuts.
19. Install the battery base bracket and battery base.
20. Install the air intake duct and intake manifold cover.
21. Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.
22. Enter the radio and navigation anti-theft codes, then enter the audio presets, and set the clock.
23. Do the power window control unit reset procedure.
