Pilot 2WD V6-3.5L (2006)
11. Connect the negative battery terminal to the solenoid valve A connector terminal No. 2, and connect the positive battery terminal to the connector
terminal No. 1.
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 12.
12. Remove the nuts securing the shift cable bracket (A).
13. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
14. Remove the bolt securing the harness cover (A).
15. Remove the harness clamp (B) from the harness cover/clamp bracket (C), disconnect the 4th clutch transmission fluid pressure switch connector
(D), then remove the harness cover from the bracket.
16. Disconnect the A/T clutch pressure control solenoid valve A connector (E), A/T clutch pressure control solenoid valve B connector (F), solenoid
harness connector, transmission range switch connector, ATF temperature sensor connector, output shaft (countershaft) speed sensor connector,
input shaft (mainshaft) speed sensor connector, and 3rd clutch transmission fluid pressure switch connector.
