Pilot 2WD V6-3.5L (2006)
Transmission Speed Sensor: Service and Repair
Output Shaft (Countershaft) Speed Sensor Replacement
Output Shaft (countershaft) Speed Sensor Replacement
1. Remove the splash shield.
2. Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A).
3. Install the new O-ring (B) on the new output shaft (countershaft) speed sensor and apply clean ATF to the O-ring, then install the output shaft
(countershaft) speed sensor in the transmission housing.
4. Check the connector for rust, dirt, or oil, then, Connect the connector securely.
5. Install the splash shield.