Pilot 2WD V6-3.5L (2006)
Shift Cable: Service and Repair
Shift Cable Replacement
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS before performing
repairs or service.
1. Remove the steering column upper and lower covers.
2. Remove the instrument panel.
3. Shift the transmission into the N position.
4. Remove the nut (A) securing the shift cable end, then separate the shift cable (B) from the shift lever.
5. Rotate the socket holder (C) on the shift cable a quarter turn; the tab (D) on the socket holder will be in the opening (E) of the socket holder
bracket (F). Then slide the holder to remove the shift cable from the socket holder bracket.
6. Get the customer's radio (and navigation) anti-theft codes, and write down the radio presets.
7. Disconnect the negative cable from the battery, then disconnect the positive cable from the battery.
8. Remove the battery hold-down bracket, and remove the battery and battery tray.
9. Remove the intake manifold cover and intake air duct.
10. Remove the battery base and battery base bracket.
11. Remove the nuts securing the shift cable bracket (A).
12. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
