Pilot 2WD V6-3.5L (2006)
13. Remove the cable clamp (A) from the shift cable bracket (B), and remove the nuts securing the shift cable bracket.
14. Remove the shift cable grommet (C), and pull out the shift cable (D).
15. Insert the new shift cable through the grommet hole (E), and install the grommet in its hole. Do not bend the shift cable excessively.
16. Secure the shift cable bracket (A) with the mounting nuts, and install the cable clamp in its bracket.
17. Attach the shift cable end (B) to the control lever (C), then insert the control pin (D) into the hole in the control lever and through the cable end.
Secure the control pin with the spring clip/washer (E).
18. Secure the shift cable bracket with the nuts on the transmission housing.
19. Verify that the transmission is in the N position at the control lever on the transmission range switch.
20. If necessary, push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not hold
the shift cable guide (B) and damper (C) to adjust the shift position.
