Pilot 2WD V6-3.5L (2006)
24. If improperly installed, remove the shift cable from the socket holder bracket, and reinstall the shift cable. Do not install the shift cable end on the
mounting stud while the shift cable is on the socket holder bracket.
25. Install and tighten the nut.
26. Remove the 6.0 mm (0.24 inch) pin that was installed to hold the shift lever.
27. Install the battery base bracket and battery base.
28. Install the intake air duct and intake manifold cover.
29. 1 Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.
30. Move the shift lever to each position, and verify that the A/T gear position indicator follows the transmission range switch.
31. 4WD model: Raise the vehicle, make sure it is securely supported, and allow all four wheels to rotate freely.
2WD model: Raise the front of the vehicle, make sure it is securely supported, and allow the front wheels to rotate freely.
32. Start the engine, and check the shift lever operation in all positions.
33. Install the instrument panel.
34. Install the steering column upper and lower covers.
35. Enter the radio and navigation anti-theft codes, then enter the radio presets and set the clock.
36. Do the power window control unit reset procedure.
