Pilot 2WD V6-3.5L (2006)
Shifter A/T: Service and Repair
Shift Lever Installation
Shift Lever Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS before performing
repairs or service.
1. Install the shift lever assembly (A) on the steering column, and install the harness clamp (B).
2. Connect the shift lock solenoid connector (C) and park pin switch connector (D).
3. Turn the ignition switch ON (II), and verify that the R position indicator comes on.
4. If necessary, push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not hold
the shift cable guide (B) and damper (C) to adjust the shift position.
5. Turn the ignition switch OFF.
