Pilot 2WD V6-3.5L (2006)
6. Place the shift lever in the N position, then insert a 6.0 mm (0.24 inch) pin (A) through the positioning hole (B) on the detent plate, and into the
positioning hole (C) on the control bracket. The shift lever is secured in the N position.
7. Align the socket holder (A) on the shift cable (B) with the slot in the socket holder bracket (C), then slide the holder into the bracket. Install the
shift cable end (D) over the mounting stud (E) by aligning its square hole (F) with the square fining (G) at the bottom of the stud. Rotate the holder
a quarter turn to secure the shift cable. Do not install the shift cable by twisting the shift cable guide (H) and damper (I).
8. Verify that the shift cable end (A) is properly installed on the mounting stud (B).
