Pilot 2WD V6-3.5L (2006)
18. Lift up the boot band tool to bend the free end of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
19. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
20. Bend the band and (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything, and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
21. Repeat steps 16 through 22 for the band on the other end of the boot.
