Pilot 2WD V6-3.5L (2006)
22. Install a new locking tab type boot band on the inboard joint side of the inboard boot. Fold down the locking tabs.
23. Lightly tap on the doubled-over portions to reduce their height.
24. Install a new set ring (A) (left driveshaft).
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damage to the outboard boot.
2. Install the new ear clamp bands (B) and outboard boot, then remove the vinyl tape. Be careful not to damage the boot.
3. Install the new circlip (A) in the driveshaft groove (B).
