Pilot 2WD V6-3.5L (2006)
3. Clean the areas where the driveshaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air. Insert the
inboard end (A) of the driveshaft into the differential (B) or intermediate shaft (C) until the set ring (D) locks in the groove (E).
4. Install the outboard joint (A) into the front hub (B).
5. Install the knuckle (A) onto the lower arm (B). Be careful not to damage the ball joint boot (C). Wipe off the grease before tightening the nut at the
ball joint. Torque the new castle nut (D) to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not
align the nut by loosening.
6. Install the new clip (E) into the pinhole as shown.
