Pilot 2WD V6-3.5L (2006)
6.
Install a new intermediate shaft heat shield with the original bolts. Torque the bolts to 22 Nm (16 lb-ft).
7.
Reinstall the exhaust pipe bracket, and torque its bolts to 22 Nm (16 lb-ft).
8.
Accord Hybrid only - Reinstall the steering rack heat shield with its original bolts. Torque the bolts to 22 Nm (16 lb-ft).
9.
Reattach exhaust pipe A to the warm-up catalytic converters with two new front gaskets and six new nuts. Torque the nuts to 54 Nm (40 lb-ft).
10.
Reattach exhaust pipe A to the TWC with a new rear gasket and three new nuts. Torque the nuts to 33 Nm (25 lb-ft).
11.
Reconnect exhaust pipe A to its rubber hanger.
REPAIR PROCEDURE B: PILOT, RIDGELINE
1.
Raise the vehicle on a lift, and make sure it is securely supported.
2.
Remove the right front wheel.
3.
Unstake the spindle nut, then remove it.
