Pilot 2WD V6-3.5L (2006)
Transmission Temperature Sensor/Switch: Service and Repair
ATF Temperature Sensor Replacement
1. Remove the splash shield.
2. Drain the automatic transmission fluid (ATF).
3. Disconnect the ATF temperature sensor connector (A), then remove the connector from the connector bracket (B).
4. Remove the harness clamp (C) from its bracket (D).
5. Remove the ATF temperature sensor, and replace the sensor.
6. Install a new O-ring (E) on the new ATF temperature sensor (F) and apply clean ATF to the O-ring.
7. Install the ATF temperature sensor connector to the connector bracket, then connect the connector securely.
8. Install the harness clamp on its bracket.
9. Refill the transmission with the ATF.
10. Install the splash shield.
