Pilot 2WD V6-3.5L (2006)
Windshield Washer Switch: Testing and Inspection
Wiper/Washer Switch Test/Replacement
1. Remove the dashboard lower cover.
2. Remove the steering column covers.
3. Disconnect the 14P connector (A) from the wiper/washer switch (B).
4. Remove the two screws, then pull out the wiper/washer switch.
5. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
6. If the continuity check is not as specified, replace the switch.
