Pilot 2WD V6-3.5L (2006)
12. Transfer the combination light switch and the wiper / washer switch to the new switch body.
13. Install the new switch body using the three screws.
14. Set the turn signal canceling sleeve so the projections are aligned vertically.
15. Carefully install the cable reel on the combination switch. Then connect the 5P connector and 4P connector.
16. Install the steering wheel column covers.
17. If needed, center the cable reel. Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise about 2-1/2 turns until
the arrow mark on the cable reel points straight up.
