Pilot 4WD V6-3.5L (2008)
Air Bag: Removal and Replacement
Driver's Airbag Replacement
Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.
3. Using a TORX T30 bit, remove the two TORX bolts (A).
4. Remove the driver's airbag (B).
Installation
1. Place the new driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B).
2. Connect the cable reel to the driver's airbag 4P connector (A), then install the access panel (B) on the steering wheel.
