Pilot 4WD V6-3.5L (2008)
8. For 2WD: Remove the rear axle shaft from the knuckle.
9. Release the parking brake, and remove the brake disc/drum from the rear hub.
10. Check the rear hub for damage and cracks.
11. Remove the parking brake shoes, and parking brake cable.
12. Remove the lock pin (A) from the upper arm ball joint, then remove the castle nut (B).
NOTE: During installation, install the lock pin after tightening the nut.
13. Disconnect the upper arm ball joint from the knuckle using the ball joint remover.
14. Remove the self-locking nut (B), washer, and flange bolt (C), then remove the lower arm A.
NOTE: During installation, install a new self-locking nut.
15. Remove the flange bolts (A), and separate the knuckle from the trailing arm (B).
NOTE: During installation, install the new flange bolts.
