Pilot 4WD V6-3.5L (2008)
13. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
14. Check the bushing (F) in the shift cable end for a proper fit and wear. If the bushing is loose or worn, replace the shift cable.
15. Remove the bolt securing the harness cover (A).
16. Remove the harness clamp (B) from the harness cover/clamp bracket (C), disconnect the 4th clutch transmission fluid pressure switch connector
(D), then remove the harness cover from the bracket.
17. Disconnect the A/T clutch pressure control solenoid valve A connector (E), A/T clutch pressure control solenoid valve B connector (F), solenoid
harness connector, transmission range switch connector, ATF temperature sensor connector, output shaft (countershaft) speed sensor connector,
input shaft (mainshaft) speed sensor connector, and 3rd clutch transmission fluid pressure switch connector.
18. Remove A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
