Pilot 4WD V6-3.5L (2008)
Shift Cable: Adjustments
Shift Cable Adjustment
SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS before doing repairs or
service.
1. Remove the steering column covers.
2. Remove the instrument panel.
3. Shift the transmission into the N position.
4. Remove the nut (A) securing the shift cable end, then separate the shift cable (B) from the shift lever.
5. Rotate the socket holder (C) on the shift cable a quarter turn; the tab (D) on the socket holder will be in the opening (E) of the socket holder
bracket (F). Then slide the holder to remove the shift cable from the socket holder bracket. Do not remove the shift cable by twisting the shift
cable guide (G) and damper (H).
6. Push the shift cable (A) until it stops, then release it. Pull the shift cable back two steps so that the shift position is in N. Do not hold the shift cable
guide (B) and damper (C) to adjust the shift position.
7. Turn the ignition switch ON (II), and check that the R position indicator comes on.
8. Turn the ignition switch OFF.
