Pilot 4WD V6-3.5L (2008)
20. Unwind the boot band tool, and cut off the excess free end of the band to leave 5 - 10 mm (0.2 - 0.4 in.) from the clip.
21. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
22. Install the boot band on the other end of the boot, and repeat steps 14 through 21.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the outboard boot.
