Pilot 4WD V6-3.5L (2008)
25. Install the hub (A) on the knuckle (B) using the attachment, the driver, the support base, and a hydraulic press. Be careful not to deform the
backing plate (C).
26. Install the knuckle in the reverse order of removal, and note these items:
^
First install all the components, and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values.
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
^
Use a new spindle nut on reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc/drum, clean the mating surfaces of the rear hub and the inside of the brake disc/drum.
^
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
^
Check the rear wheel alignment, and adjust it if necessary.
