Pilot 4WD V6-3.5L (2008)
Torque Converter Clutch Solenoid: Testing and Inspection
Shift Solenoid Valve A, B, and C, Torque Converter Clutch Solenoid Valve Test/Replacement
1. Connect the HDS to the DLC (A).
2. Choose Shift Solenoid A, B, C, and Lockup Solenoid Test in the Miscellaneous Test Menu on the HDS.
3. Check that shift solenoid valve A, B, C, and the torque converter clutch solenoid valve operate with the HDS. A clicking sound should be heard.
^
If a clicking sound is heard, the valves are OK. The test is complete, disconnect the HDS.
^
If no clicking sound is heard, go to step 4, and test the solenoid valves.
4. Make sure you have anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
5. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
6. Remove the battery hold-down bracket, and remove the battery and battery tray.
7. Remove the intake manifold cover and the intake air duct.
8. Remove the battery base and battery base bracket.
9. Remove the nuts securing the shift cable bracket (A).
10. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
11. Check the bushing (F) in the shift cable end for a proper fit and wear. If the bushing is loose or worn, replace the shift cable.
12. Remove the bolt securing the harness cover (A).
