Prelude L4-1829cc 1800 ES,ET (1983)
Heater Control Panel: Customer Interest
Heater - Labels On Control Panel Lift Up or Fall Off
Model
Applicable To
File Under
Bulletin No.
PRELUDE
'83-'85
BODY
85-001
Issue Date JAN 4, '85
Labels on Prelude Heater Control Panel
PROBLEM Labels on the heater control panel lift up or fall off.
Labels on Prelude Heater Control Panel
CORRECTIVE ACTION
1.
If the label is still partially stuck to the panel, carefully peel it all the way off.
2.
With alcohol and a shop towel, clean the surface of the heater control panel where the label attaches. Also clean the back of the original label if
you're going to re-use it.
3.
Apply the label.
New Label:
^
Peel the tape off the back of the label.
^
Firmly press the label into position.
^
Peel the clear protective film off the label.
Original Label:
^
Apply two or three very small drops of cyanoacrylate adhesive (Super Glue [TM] or Crazy Glue [TM]) to the back of the label, but only in
the areas you can't see through (hold the label up to the light).
CAUTION: If any adhesive spreads to the areas you can see through, it will affect the illumination of the label when the dash lights are on.
^
Press the label into position and hold it there firmly until the adhesive sets (time listed on the container).
PARTS INFORMATION
Fan-speed label
H/C 1958719
P/N 39393-SB0-003
Temperature label
H/C 1958727
P/N 39394-SB0-003
Blank label
H/C 1975325
P/N 39395-SB0-003
WARRANTY CLAIM INFORMATION
Operation number:
610215 - Replace one or more labels.
Flat rate time:
0.2 Failed part H/C: 197532
Defect code:
025
Contention code:
A02