Prelude L4-1958cc DOHC (1989)
1.
Refer to Figs. 22 through 26 when replacing rear brake pads.
2.
Raise and support rear of vehicle, then remove wheel and tire assemblies.
3.
Remove two caliper mounting bolts, then caliper.
4.
Remove shims, retainers and brake pads.
INSTALLATION
Fig. 27 Aligning Caliper Piston
1.
Using a vernier caliper, measure thickness of each pad lining. Compare measurement with specifications. If brake lining thickness is less than
specified, replace both pads as a set.
2.
Clean caliper thoroughly, and check for grooves or cracks, repair or replace as necessary.
3.
Install pad retainers, then apply Molykote M77 compound or equivalent to both sides of pad shim and install brake pads and pad shims.
4.
Rotate caliper piston clockwise into place, then align cutout in piston with tab on inner pad by turning piston back. Lubricate piston boot with
silicone grease to avoid twisting piston boot. If boot is twisted, back it out until it sits properly, Fig. 27.
5.
Install caliper, then caliper bolts and tighten to specified torque.
6.
Install wheel and tire assembly and lower vehicle.
7.
Pump brake pedal several times to position brake pads before moving vehicle.
