Prelude L4-1958cc DOHC (1989)
Alignment: Service and Repair
Alignment
Rear
Fig. 7 Rear Toe-in Adjustment
2 Wheel Steering
Ensure tires are properly inflated prior to checking or adjusting toe-in.
1.
Release parking brake.
2.
Loosen locknut in rear radius arm pivot bolt, then turn adjusting bolt, Fig. 7, until toe-in is within specifications.
3.
Torque locknut to 33 ft. lbs.
4 Wheel Steering
1.
On 1992,93 Preludes with 4 wheel steering, set rear main steering angle sensor in Neutral position and jumper service check connector. This will
turn 4WS indicator On.
2.
Rear toe is adjusted by loosening the tie rod end lock nuts and rotating the tie rods. After completing adjustment, torque tie rod end lock nuts to
33 ft. lbs.
Two Wheel Steering - 2WS
Wheel Alignment
Preparation
1. Check the tire pressure.
2. Check the steering wheel angle.
If significantly off center, it may be necessary to remove the steering wheel and reposition it on the splines.
Turn the steering wheel to the straight-ahead position.
Alignment should be checked/adjusted in one continuous procedure: caster, front camber, rear camber, rear toe, front toe and steering wheel alignment.
Front Caster:
