Prelude L4-1958cc DOHC (1989)
Spark Plug Wires: Testing and Inspection
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wire or the conductor may be broken.
Typical Wire Inspection
1.
Check the condition of the wire terminals. If any terminal is corroded, clean it and if it is broken or distorted, replace the wire.
Typical Wire Inspection
2.
Connect ohmmeter probes and measure resistance.
Resistance:
25K ohms max. at 68°F (20°C)
3.
If resistance exceeds 25k ohms, replace the ignition wire.
