Prelude L4-1958cc DOHC (1989)
Electronic Noise Suppressor: Testing and Inspection
Radio Condenser Capacity Test
NOTE: Capacitance can be tested with a higher quality digital volt/ohm meter, however, a commercial condenser tester can be used to stress test and
check leakage on a condenser
1.
Use a commercially available condenser tester. Connect the tester probes and measure the condenser capacity.
Condenser capacity: 0.47 +/- 0.09 microfarads
NOTE:The radio condenser is intended to reduce ignition noise; however, condenser failure may cause the engine to stop running.
2.
If not within specification replace the radio condenser.