Prelude L4-1958cc SOHC (1988)
4.
Remove the brake booster vacuum line from the left side of the intake manifold.
5.
Disconnect the air intake temperature sensor connector (located on the left side of the intake manifold.
6.
Disconnect the P/S pressure switch connector (on the brake booster side) and the harness clamp (located half way down the harness).
7.
Disconnect the fuel return hose from the fuel pressure regulator
8.
Remove the injector resistor and ground strap.
9.
Remove the clutch reservoir mounting bolts and lay the reservoir against the intake manifold. (Manual transmission models only.) Remove the
resistor harness clip from the clutch reservoir bracket.
10.
Remove the resonator chamber connecting tube and the left and right resonator chamber flange bolts. (The rear resonator chamber attachment bolt
will be removed from under the car in step 14.)
11.
Remove the P/S supply hose bracket bolt (next to the left side resonator chamber attachment bolt).
12.
Place a clean protective cloth over the alternator, then remove the two bolts at the joint of the P/S pump and the P/S supply hose. Separate the
supply hose from the pump.
13.
Remove the P/S supply hose bracket bolts from the cylinder block (8 mm) and thermostat housing (6 mm).
14.
Raise the vehicle and remove the rear resonator chamber attachment bolt, then move the chamber up and to the right side of the engine
compartment.