Prelude L4-1958cc SOHC (1988)
3.
Pull CYL coil assembly and mount rubber out from sensor housing by removing screws.
4.
Remove C-clip.
5.
Slide off pin retainer, being careful not to stretch it.
6.
Separate coupling from shaft by removing roll pin, then remove rotor shaft.
7.
Apply molybdenum disulfide grease to sensor housing and install washers on rotor shaft, then install shaft in sensor housing and install new C-clip.
8.
Install coupling with index mark facing as shown, Fig. 43, then install pin and the pin retainer.
9.
Install mount rubber, then the CYL coil assembly and the CYL rotor. Install rotor with part number facing up and install roll pin so that it faces as
shown, Fig. 44.
10.
Adjust air gap, Fig. 45.
11.
Install new O-ring on sensor housing, then slip sensor into position.
