Prelude L4-1958cc SOHC (1988)
6.
From the bottom of the throttle stopper support, push the 6 mm hex nut into the hole until it bottoms.
7.
Put the throttle stopper support in place and bend the bracket so it fits snugly against the support.
8.
Install the special 6mm screw and tighten the 6 mm hex nut to 10 N-m (1 kg-m, 7 lb.ft.).
9.
Roll the floor pads and the carpet back into position.
10.
Si model only: Install the foot rest mounting bolts loosely.
11.
Reinstall the left kick panel cover.
12.
Attach the lower mounting clip to the cover and then guide the tip of the clip through the carpet and into the mounting hole.
13.
Reinstall the top left carpet clip.
14.
Si model only: Tighten the foot rest mounting bolts.
15.
Reinstall the side-sill garnish.
16.
With the engine OFF, check the throttle pedal stroke by depressing the throttle fully and releasing several times.
17.
Center punch a recall completion mark above the "M" of the VIN on the firewall.
PARTS INFORMATION
Accelerator pedal bracket support kit:
P/N: 61010-SF1-305
H/C: 3265360
Kit contents:
Support
(1)
Special screw (6 X 16 mm)
(1)
Hex nut (6 mm)
(1)
WARRANTY CLAIM INFORMATION
