Prelude L4-1958cc SOHC (1988)
13.
Install the P/S supply hose bracket A to the cylinder block. Fit the clamp around the supply hose and then install it onto the bracket (make sure the
clamp is facing up).
Install bracket B to the thermostat housing. Fit the clamp around the supply hose and then install it on to the bracket (make sure the clamp is facing
down).
14.
Reinstall the injector resistor and ground strap. Reinstall the clutch reservoir (M/T only).
15.
Reinstall the fuel return hose to the fuel pressure regulator.
16.
Reconnect the P/S pressure switch connector and attach the harness bracket to the brake booster vacuum hose.
17.
Reconnect the air intake temperature sensor connector.
18.
Reinstall the brake booster vacuum hose.
