Prelude L4-1958cc SOHC (1988)
Reinstalling the New P/S Supply Hose:
1.
Install the P/S supply hose from the right side of the engine compartment by feeding the flare nut end down behind the rear beam until a
considerable amount of hose is below the rear beam.
2.
Raise the vehicle.
3.
Continue to pull the supply hose down and to the left side of the vehicle.
4.
Lower the stablizer bar and exhaust pipe A, then position the supply hose on the upper side of the rear beam.
5.
Loosely connect the supply hose flare nut to the valve body.
6.
Loosely connect the sensor pipe to the valve body.
7.
Install the return pipe and sensor pipe in the clamps located on the back of the rear beam.
8.
Reconnect the return pipe to its hose section and install the clamp.
9.
Reconnect exhaust pipes A and B. Torque to 24.5 ft.lb. (3.4 kg-m). (Use new self-locking nuts and gasket.)
10.
Reinstall exhaust pipe A rubber mount.
11.
Reinstall the front stabilizer bar. Torque to 15.8 ft.lb. (2.2 kg-m) (Bolt/washer 8 x 16 mm).
