Prelude L4-2.2L SOHC (1994)
^ Be careful not to damage the ball joint boot.
^ Torque the castle nut to the lower torque specification then tighten it only far enough to align the slot with the pin hole. Do not align the nut by
loosening.
37. Install the knuckle on the driveshaft.
38. Install the knuckle on the lower arm and the tie-rod, then tighten the castle nuts and install new cotter pins.
39. Install the knuckle on the upper arm, then tighten the castle nut and install a new cotter pin.
40. Install the knuckle protector with the 6 mm bolt.
41. Install the speed sensor with the sensor mounting bolts.
NOTE: Be careful when installing the sensors to avoid twisting wires.