Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
_mfi/Page-566001.png)
Ignition Cable: Testing and Inspection
Ignition Wire Inspection and Test
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wires; you might break them inside.
1. Check the condition of the wire terminals. If any terminal is corroded, clean it, and if it is broken or distorted replace the wire.
2. Connect ohmmeter probes and measure resistance.
Ignition Wire Resistance: 25 kOhm max. at 68°F (20°C)
3. If resistance exceeds 25 kOhm, replace the ignition wire.
