Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
7. Using a cutter or an equivalent tool, cut the valve seal ring and O-ring at the groove the pinion shaft. Remove the valve seal ring and O-ring.
CAUTION: Be careful not to damage the edges of the pinion shaft groove and outer surfaces when removing the valve seal ring and O-ring.
8. Remove the valve oil seal and backup ring from the pinion shaft.
NOTE:
-
Inspect the ball bearing by rotating the outer race slowly. If there is any excessive play, replace the pinion shaft and sleeve as an assembly.
-
The pinion shaft and sleeve are a precise fit; do not intermix old and new pinion shafts and sleeves.
9. Press the valve oil seal and roller bearing out of the valve housing using a hydraulic press and the special tool.
Assemble
NOTE: