Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
Bell Housing: Service and Repair
REMOVAL
NOTE:
-
If the transmission housing or clutch housing are replaced, the bearing preload must be adjusted.
-
Place the clutch housing on two pieces of wood thick enough to keep the mainshaft from hitting the workbench.
1. Remove the shift arm cover assembly.
2. Remove the reverse idler gear shaft bolt.
3. Remove the setting screws, then remove the washers, springs, and steel balls.
4. Remove the back-up light switch.
5. Remove the 10 mm bolts and 8 mm bolts in a crisscross pattern in several steps.