Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
_16v/Page-576002.png)
3. Reinstall the drain plug with a new washer, and refill with the recommended oil.
NOTE: Under normal conditions, the oil filter should be replaced at every other oil change. Under severe conditions, the oil filter should be
replaced at each oil change.
The numbers in the middle of the API Service label tell you the oil's SAE viscosity or weight. Select the oil for your vehicle according to this
chart:
An oil with a viscosity of 5W - 30 is preferred for improved fuel economy and year-round protection in the vehicle. You may use a 10W - 30 oil if
the climate in your area is limited to the temperature range shown on the chart.
4. Run the engine for more than three minutes, then check for oil leakage.
OIL FILTER
Replacement Except M/T With ATTS:
WARNING:
-
After the engine has been run, the exhaust pipe will be hot; be careful when working around the exhaust pipe.
-
Be careful when loosening the drain bob while the engine is hot. Burns can result because the oil temperature is very high.
