Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
_16v/Page-600001.png)
Balance Shaft Seal: Service and Repair
CRANKSHAFT AND BALANCER SHAFT OIL SEALS INSTALLATION (ENGINE REMOVAL NOT REQUIRED)
NOTE: The crankshaft and front balancer shaft oil seal housing surface should be dry.
OIL: Apply a light coat of grease to the crankshaft, the balancer shaft and to the lips of the seals.
1. Using the special tool, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess
grease off the crankshaft, and check that the oil seal lip is not distorted.
2. Using the special tool, press in the front balancer shaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any
excess grease off the balancer shaft, and check that the oil seal lip is not distorted.
3. Using the special tool, drive the crankshaft oil seal into the right side cover to the point where the clearance between the bottom of the crankshaft
