Prelude Type-SH L4-2157cc 2.2L DOHC H22A4 (VTEC) 16V (1998)
_16v/Page-499007.png)
35. Install the hub on the knuckle using the special tools shown and a hydraulic press.
CAUTION: Take care not to distort the splash guard.
36. Install the knuckle in the reverse order or removal, and pay particular attention to the following items:
-
Be careful not to damage the ball joint boots when installing the knuckle.
-
Torque all mounting hardware to the specified torque values.
-
Torque the castle nuts to the lower torque specifications, then tighten them only far enough to align the slot with the pin hole. Do not align the
castle nut by loosening.
-
Install new cotter pins on the castle nuts after torquing.
-
Avoid twisting the sensor wires when installing the wheel sensor.
-
Before installing the brake disc, clean the mating surfaces of the front hub and the inside of the brake disc.
-
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
-
Check the front wheel alignment, and adjust it if necessary.
NOTE: Make sure the front wheels are in the straight ahead position (mechanical neutral) after the wheel alignment, then let the ATTS control
unit memorize the neutral position.
